The slime dryer equipment is the main mechanical equipment for coal washing plants, coal mines and other coal enterprises to recycle and use the washed slime. Compared with the fast drying of the slime, it has a shorter period, the daily processing capacity of the slime is large, and the moisture of the dried slime is 15%. Below, the combustibility is good, the slime drying project covers a small area and requires low manpower. The important thing is that the new slime dryer equipment adopts clean heat sources, fuels such as gas and oil, steam waste heat and other heating methods. The slime dryer is environmentally friendly and has low consumption, and will not have the characteristics of dust pollution and rainwater pollution.
This coal dryer equipment can be used for drying all kinds of coal, lignite, carbon coal, including anthracite, lean coal and poor lean coal, lean coal, coking coal, fat coal, air fertilizer coal, gas coal, coal and weakly caking coal, not sticky coal, long flame coal, lignite, coal washing, screening, raw coal, bituminous coal,the tail coal, midding coal, etc. Equipment can be made according to the customers' requirements.
Coal drum dryer is mainly composed of hot blast stove, belt feeding machine, drum dryer, belt discharging machine, induced draft fan, cyclone dust collector, bag filter (or wet dust collector) and operation control system.
Equipment used downstream drying process, its working principle is as follows: wet material after entering the drying drum divided into the following workaround:
1. Feeding area, the coal into the area exchanged with high temperature and hot air quickly evaporate moisture, the material in large Angle of guide plate copy, to be imported under a workspace.
2. The crushing beat cleaning area, equipment design in this area have broken beat cleaning device, wet mud grabbed by grating copy board has broken beat, big wet mud after repeated broken beating, which is broken into 20-40 mm particles slimeball, forming curtain material status, increase the heat exchange area, improve the drying rate, reasonably cleaning the mud in the cylinder wall, and prevent mud adhesion.
3. Main drying area, through two areas processing wet mud, has a granular loose state, the material in this area is inclined by feed plate copying, form a uniform state of the material, then have full heat exchange with the hot air, strong evaporation.
4. Pounding broken dry area, in the region after repeated pounding broken mud, mud particles from 20-40 mm broken into 10-20 mm size (request), and moisture further reduced.
