For the mechanical equipment such as the bean dregs dryer, there will be a certain running-in period. How to safely pass the running-in period of the drying equipment? Dingli will give you a few tricks.

  The running-in period of the bean dregs dryer is called trial operation. According to the different specifications of the equipment, it is usually 3-10 days. The purpose of running-in is to prevent the early wear and tear of the equipment and prolong the service life. These are not to be introduced too much.

  1. During the trial operation of the bean dregs dryer, always pay attention to the operation of each part, check the working status of the bearings and gears of each part, and stop the abnormality during operation to check the cause and eliminate it.

  2. The technical preparation before the start of the bean dreg dryer, the technical requirements during the operation, the technical work before the stop and after the flameout, etc. are carried out according to the requirements of the general mechanical operation rules.

  3. After the running-in period is over, the inspection, adjustment and lubrication of the bean dreg dryer should be carried out according to the operation during the running-in period.

  Dingli believes that the technical personnel should strengthen the technical management of the running-in period of the bean dregs dryer, and clearly explain the requirements and precautions of the running-in period to the operators; check the use and operation of the equipment, and fill in the usage record form in detail, earnestly and truthfully. Prepare all the preliminary work thoroughly, and then stabilize the operation when it is actually produced in the later stage, so as to avoid penny wise and pound foolish.